EvenSkyn® Lumo+
Radiofrequency:
1 Megahertz
Voltage range (Level 1 to level 5): 97V to 118V
Electrical Muscle Stimulation:
ION: 2.75mA
ENI: 2.75-12.5mA
EMS: 3mA-15mA
Light Therapy:
Red Light: 623nm
Blue Light: 465nm
Sonic Massaging:
ION: 100Hz
ENI: 10Hz
EMS: 100Hz
Technical:
Battery Specification: 7.4V, 650 mAh
Adapter: Input 100~240V,0.35A Output 9V 1.5A
Rated Power: About 10V
Bare Weight: About 350g
Full-charge time: About 2 hours
Safety Certifications: FDA, Health Canada, CE, EMC, RoHS, CQC, PES compliant
The 15% Off discount code LUMOSALE will be automatically applied at checkout.
Designed in Canada
Free Shipping in US & CA
FDA Approved
How it works
- Lumo’s unique two-tier dermal heating system is only available in commercial machines. The higher tier of heating is only triggered for a few seconds (less than 20 seconds) on cooler skin and where the dermal temperature is detected as being higher, the features automatically defaults to the lower heating of 42 degree Celsius.
- The Lumo’s RF core has a proprietary targeting system that delivers 95% heat into the dermal layer and features an active semiconductor-based cooling system that removes excess heat from the skin.
- The Lumo is built with titanium electrodes, medical-grade stainless steel, and twice the number of sensors of most competing devices.
- EMS mode operates at 100 Hz/s and packs an average power of 3mA, making it more powerful than typical microcurrent-only devices. Its EMS mode used once a week can provide ongoing benefits for at least 72 to 96 hours post-use.
What's included
- The EvenSkyn Lumo Device
- Travel Case (with additional storage pockets to fit the Venus) ($39.99 Value)
- EvenSkyn Conduction Gel (300 ml) ($59.99 Value)
- Power Adapter
- User Manual
Conduction Gel Ingredients
- Aqua (Water)
- Glycerin
- Hyaluronic Acid
- Amino Acids
- Hydroxyethyl Cellulose
- Peptides
- Methylparaben
- Triethanolamine
We believe that our story is best told through your skin
Watch moreFeatures
Included treatment
Discover the transformative treatments and cutting-edge features that come included with our products.
RF - Radio Frequency
RF waves that penetrate up to 3mm deep and warm the dermis layer up to 140°F to promote the remodelling & growth of collagen.
EMS - Electrical Muscle Stimulation
Deeply stimulates facial muscles with patented electrical impulse strengthening muscles to visibly lift, tone and tighten, giving you the appearance of a firmer, more youthful face.
Photorejuvenation
Red light phototherapy help reduce wrinkle severity by increasing blood circulation, along with fibroblast, and collagen.
Photorejuvenation
Blue Light helps soothe & calm the skin and kill acne-causing bacteria.
ION - Deep Cleansing
Active Ionic Export and Radio Frequency to assist with deep facial cleansing of excess oils, dead skin and build-up.
ENI - Electric Nutrient Iontophoresis
Iontophoresis, RF, red light and sonic vibrations come together to assist in the absorption of water-based products to enhance the results of your skincare products.
Bundles & Sets
Wanna Cover Eyelids too?
$709.98 $849.98 Save $140
Bring your at-home skincare to a professional-grade with our exclusive bundles!
How to use the Lumo
Unleashing the Power of Dermal Technology
Prep your skin
Prior to use ensure that the area to be treated has been thoroughly cleaned. The skin needs to be free of oils when using the device in its first four modes (RF, ION, ENI & EMS). We recommend using the EvenSkyn Conduction Gel for conductivity and seamless glide of the device. And, you can use any favourite water-based serums or moisturizers in the ENI mode (the absorption mode).
Maximizing Results
Alternate between the modes as you prefer. The Lumo has 5 different modes (with 5 intensity levels), we recommend starting with the lowest settings and adjusting depending on your comfortability and toleration. Each mode has a pre-programmed maximum duration, after which the Lumo will revert to being in standby mode.
Tighten & Lift
The Lumo needs to be in slow but constant motion, to ensure uniform dermal stimulation, and avoid aver-heating. If all the modes of the devices are used to the pre-programmed maximum duration, this should be the maximum usage in a single session, as the amount of RF wave usage duration should not exceed 25 minutes per week (if you’re treating the neck as well)
Optimal Usage Frequency for Lumo
These guidelines optimize EvenSkyn Lumo’s benefits while ensuring safe usage based on your age group. Please keep in mind that these are suggestions, not strict rules. Listen to your body and seek advice from a healthcare professional if needed.
Usage | Age: Below 40 | Age: Above 40 |
---|---|---|
No. of session per week | 1 to 2 | 2 to 3 |
Duration per session | 5 - 8 minutes | 5 - 8 minutes |
Minimum days between sessions | Min. 3 days | Min. 2 days |
Intensity per session | Up to level 4 | Up to level 5 |
Total max. duration per week (face) | ~ 15 minutes | ~ 20 minutes |
Total max. duration per week (face & neck) | ~ 20 minutes | ~ 25 minutes |
FAQ
Our FAQs section provides answers to common questions about our products, services, and terms. But if you can’t find the answer to your specific question, please feel free to message us and we’ll be happy to assist you.
More FAQsDoes Lumo RF cause fat loss?
The Lumo’s targeted RF focuses specifically on the narrow dermal layer containing collagen, with its bipolar modality most of the targeting occurrs within 1-3mm depth. The Lumo does not interact with the subcutaneous fat layer, which sits at 6mm or deeper. Check out this study on RF skin tightening:
Find study
Is the Lumo safe to use with BOTOX and/or Fillers?
The Lumo is safe to use with all major approved dermal and sub-dermal fillers. The RF’s heating when using the Lumo is much lower than tolerable by the fillers, and as such, there are no current contraindications against using it if you already have fillers or are considering getting them. However, we recommended waiting two weeks before doing your first Lumo session after the injection.
However, it’s important to note that if the fillers are placed higher in the skin, there may be rare cases where they could be impacted, and it’s best to consult a dermatologist to ensure maximal safety and clarity.
Can I use the devices if I have Hyperpigmentation or Melasma?
Yes. In most cases, radio frequency skin tightening generally is fine because the convergence of the RF waves happens in the dermal layer, which is below the topical epidermal layer, where most of the melanocytes (pigment-reducing cells) exist.
I have metal implants/screws in my face. Is it safe to use the Lumo?
While there are no contraindications for implants and/or screws that lay much lower than the 4mm penetration depth of the Lumo’s RF waves, consulting a medical practitioner intimately familiar with one’s unique medical condition is recommended because in addition to the lesser concern of overheating the material, conduction may also become a potential issue where the EMS microcurrent comes on.
If the metal lies much lower, there should ideally be no issue using the RF-only mode of the Lumo to rejuvenate the collagen in the dermis. But again, as mentioned above, every person’s implants and medical condition make their situation unique. Thus it’s best to consult your medical doctor before using a device such as the Lumo that combines microcurrent, radio frequency, phototherapy, and sonic massage therapy to deliver the best anti-aging goals.